XINLI BOILER

Oct 09, 2021

Biomass boilers use specific biomass pellet fuels. This biomass pellet fuel is produced from agricultural and forestry surplus wood materials, such as straw, waste wood, and sawdust through a series of processing. Carbon and environmentally friendly renewable resources, and the use cost is far lower than coal, petroleum and other energy sources. Biomass pellet fuel has the advantages of low carbon and environmental protection, low cost, high efficiency and energy saving;

Oct 08, 2021

After long-term operation of the biomass boiler, the heating surface is prone to fouling and coking, resulting in deterioration of heat transfer. For the tail flue, due to the long-term accumulation of combustibles, there will be reburning accidents.

Oct 06, 2021

Biomass boilers carry out the incineration of biomass materials in a timely manner. The methods of timely incineration of biomass include stove incineration, heating furnace incineration, and waste incineration. Most of the original heating and heating machinery and equipment are electric power projects, and gas or lighter oil may be used as raw materials.

Oct 04, 2021

Adopt the constant pressure mode of the make-up water pump: when the pressure of the heating system is high, the pressure required by the system cannot be known when the water tank is used. At this time, the constant pressure mode of the make-up water pump should be adopted. This constant pressure method is widely used in biomass boiler heating systems.

Oct 02, 2021

1. According to the amount of steam required for industrial production, reasonably select the rated power of biomass boilers and oil-gas boilers and the number of boilers. The higher the match between these two conditions and the actual use, the smaller the exhaust loss, and the more obvious the effect of reducing energy consumption;

Sep 30, 2021

Under normal circumstances, the thermal efficiency of biomass boilers is often affected by the thickness of the material layer. When the thermal efficiency is high, the thickness of the material layer usually needs to be controlled at about 300mm, and the thickness of the material layer at this time should be kept as constant as possible.